FixVault
Home › Jeep › 2015 › Compass Limited, AWD, Automatic CVT Trans › Repair and Diagnosis › External Pages › Different car › Section 290 (Electronic Control Modules (Service Information)) › Module, Compass › Installation › Installation

Module, Compass: Installation: Installation

WARNING: This page is about a different car, the 2014 Jeep Patriot and 2014 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The Remote Compass Module (RCM) must be calibrated after installation.

Fig 1: Identifying Remote Compass Module (RCM), Instrument Panel, Screws & Electrical Connector
GC0098553Courtesy of CHRYSLER GROUP, LLC
  1. Position the RCM (1) on top of the instrument panel (2).
  2. Install the screws (3) that secure the RCM to the instrument panel.
  3. Connect the electrical connector (4).
  4. Install the instrument panel top cover. Refer to COVER, INSTRUMENT PANEL, INSTALLATION .
  5. Reconnect the negative battery cable.
  6. Calibrate the compass module.
About FixVault