Section 303 (Charging System (Service Information)): Generator: Removal: Diesel

WARNING: This page is about a different car, the 2014 Jeep Patriot and 2014 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Air Inlet Tube

Courtesy of CHRYSLER GROUP, LLC

Remove the air inlet tube (2).

Fig 2: Identifying Bolts & Belly Pan
Courtesy of CHRYSLER GROUP, LLC
Disconnect and isolate the negative battery cable.
If equipped, remove the belly pan (2).

Fig 3: Identifying Main Drive Belt
Courtesy of CHRYSLER GROUP, LLC
Partially drain the radiator. Refer to STANDARD PROCEDURE .
Remove the serpentine belt (3). Refer to BELT, SERPENTINE, REMOVAL .

Fig 4: Identifying Radiator Support Shroud
Courtesy of CHRYSLER GROUP, LLC
Remove the radiator support shroud.

Fig 5: Identifying Hood Release Cable
Courtesy of CHRYSLER GROUP, LLC
Disconnect the hood release cable (2).

Fig 6: Identifying Power Steering Reservoir
Courtesy of CHRYSLER GROUP, LLC
Remove bolt (1) and position aside the power steering reservoir (2).

Fig 7: Upper Core Support Seal Push Pins & Radiator Core Support Bolts
Courtesy of CHRYSLER GROUP, LLC
Remove the radiator core support.

Fig 8: A/C Compressor-R & I
Courtesy of CHRYSLER GROUP, LLC
Remove bolts (2) and position aside the A/C compressor (1).

Fig 9: Identifying Upper Radiator Hose
Courtesy of CHRYSLER GROUP, LLC
Disconnect the upper radiator hose (1) from the radiator.

Fig 10: Identifying Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the generator field wire harness connector (1).
Remove nut (2) and the B+ cable from the generator.

Fig 11: Identifying Generator Mounting Retainer
Courtesy of CHRYSLER GROUP, LLC
Remove the bottom generator mounting bolt (2).

Fig 12: Identifying Upper Generator Mounting Bolt & Generator
Courtesy of CHRYSLER GROUP, LLC
Remove upper bolts (2) and the generator (2).