Sensor, Crankshaft Position: Installation: Installation

Fig 1: Crankshaft Position Sensor

Courtesy of CHRYSLER GROUP, LLC

Check O-ring for damage and lubricate the O-ring with engine oil before installing sensor.
Using a twisting motion, install the crankshaft position sensor.
Install the crankshaft position sensor bolt. Tighten the bolt to 9 N.m (80 in. lbs.).

Fig 2: Crankshaft Position Sensor
Courtesy of CHRYSLER GROUP, LLC
Connect and lock the electrical connector to the crankshaft position sensor.

Fig 3: Maniverter Side Heat Shield
Courtesy of CHRYSLER GROUP, LLC
Install the heat shield (3) with one nut (1) and two heat shield retaining bolts (2).

Fig 4: Upstream O2 Sensor Wire Harness Retainer
Courtesy of CHRYSLER GROUP, LLC
Install the upstream O2 sensor wire harness retainer (1) and crankshaft position sensor wire harness retainer (2) to the heat shield (3).

Fig 5: Air Cleaner Housing
Courtesy of CHRYSLER GROUP, LLC
Install the air cleaner body (1). Refer to BODY, AIR CLEANER, INSTALLATION, 2.0L or BODY, AIR CLEANER, INSTALLATION, 2.4L .

Fig 6: Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Connect the negative battery cable.
Install the engine cover (1).

NOTE:

The Cam/Crank Variation Relearn procedure must be performed using the scan tool anytime there has been a repair/replacement made to a powertrain system, for example: flywheel, valvetrain, camshaft and/or crankshaft sensors or components. Refer to STANDARD PROCEDURE .