FixVault
Home › Jeep › 2017 › Cherokee Trailhawk, 3.2L Eng VIN S › Repair and Diagnosis › Engine Mechanical › Fuel System › Fuel Injection, Diesel › Sensor, Air Temperature, Inlet › Installation › Installation 2.2L

Installation 2.2L

GC0170021Courtesy of CHRYSLER GROUP, LLC
  1. Install the inlet air temperature sensor (2) into the Charge Air Cooler (CAC) inlet tube. Tighten the sensor to the proper torque. Refer to TORQUE SPECIFICATIONS  .
  2. Connect the inlet air temperature sensor wire harness connector (1).
  3. Install the right front wheelhouse splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
  4. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.
About FixVault