FixVault
Home › Jeep › 2017 › Wrangler Rubicon, Automatic Trans › Repair and Diagnosis › External Pages › Different car › Section 5 (Electronic Control Modules (Service Information)) › Module, Glow Plug › Removal

Module, Glow Plug: Removal

WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
GC0146750Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Disconnect the two glow plug harness connector (3).
  3. Remove the nut (1) and the glow plug module (2).
About FixVault