Installation - Power Distribution Z-Case Fuse Array
WARNING: This page is about a different car, the 2017 Jeep Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the Z-case fuse array to the Power Distribution Center (PDC).
- Press the Z-case down into position until the tabs (3) snap around the outer edges of the array indicating the array is firmly seated.
- Install and tighten the screw (1) that secures the fuse array to the PDC case and tighten the screw to 9 N.m (80 In. Lbs.).
- Connect all power feeds to their proper locations.
- Secure the feeds to their posts (2) and tighten the screws to 9 N.m (80 In. Lbs.).
- Install the PDC cover into proper position on the PDC assembly.
- Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector to the negative battery cable.