FixVault
Home › Jeep › 2017 › Wrangler Rubicon, Automatic Trans › Repair and Diagnosis › Transmission › Automatic Trans › Engine Cooling System › Engine › Tube, Water Inlet › Removal

Tube, Water Inlet: Removal

  1. Disconnect and isolate the negative battery cable.
  2. Remove the thermostat housing assembly. Refer to THERMOSTAT, REMOVAL .
    GC0148207Courtesy of CHRYSLER GROUP, LLC
  3. Remove the lower oil cooler supply hose (4) located below the water inlet tube (5).
    GC0148210Courtesy of CHRYSLER GROUP, LLC
  4. Remove the water inlet tube mounting bolts (1).
  5. Remove the water inlet tube from the backside of the water pump and discard O-ring seal.
About FixVault