Removal And Installation: Installation

WARNING: This page is about a different car, the 2017 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of CHRYSLER GROUP, LLC

Position the instrument cluster (2) close enough to the instrument panel to access and connect the instrument panel wire harness connector to the receptacle on the back of the cluster housing.
Install and securely tighten the four screws (1) that secure the instrument panel cluster (2) to the instrument panel.
Install the instrument cluster bezel (Refer to REMOVAL AND INSTALLATION ).
Connect the battery negative cable.
NOTE:
If this Electronic Control Unit (ECU) is being replaced with a new unit, a diagnostic scan tool MUST be used to align the PROXI configuration data into the new ECU. Follow the routine outlined in the diagnostic scan tool for PROXI Configuration Alignment under Body Control Module (BCM) Miscellaneous Functions menu. Once the PROXI Configuration has been completed, tire pressure placard values must be programmed in the RF Hub under "Update Front and Rear Axle Nominal Tire Pressure Values". If this routine is not completed, the new Instrument Cluster will display "0 PSI" for tire pressure values as default.