Module, Drivetrain Control: Installation: Installation
WARNING: This page is about a different car, the 2016 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
- Position the Drive Train Control Module (DTCM) (3) in the mounting bracket.
- Slide the module into place until the locking tabs are secure.
- Connect the body wire harness connector to the module connector receptacle.
- Install the cover panel onto the electronic module tub (4).
- Connect the negative battery cable. Refer to CABLES, BATTERY, INSTALLATION for battery location and cable connection procedure.
- If replacing the DTCM, the transfer case, or both, use the scan tool to perform the Non-Volatile Memory Reset procedure.
- Perform the DTCM verification test. Refer to STANDARD PROCEDURE .