Isolator, Front CROSSMEMBER, Frame: Installation

Courtesy of CHRYSLER GROUP, LLC

CAUTION:

It is very important that isolator be installed in same position as original to maintain vehicle ride quality and isolator longevity. That is why isolator, once installed, needs to closely match reference marks applied upon removal of original isolator.

Position isolator (3) on crossmember (1) isolator bore aligning isolator can flange with reference marks applied during removal.

Courtesy of CHRYSLER GROUP, LLC

1 - Press, Ball Joint C-4212F

2 - Remover/Installer, Bushing 9031-5A

3 - Remover/Installer, Bushing 9031-7A

4 - Front Engine Cradle Crossmember

5 - Isolator

NOTE:

Prior to using special tools, lubricate Press, Ball Joint (special tool #C-4212F, Press, Ball Joint) (1) threads to provide ease of use and promote tool longevity.

NOTE:

A mixture of soap and water may be used to aid installation of the isolator.

Assemble tools over isolator as shown.
Tighten Press, Ball Joint (special tool #C-4212F, Press, Ball Joint) (1) screw-drive, pressing isolator (5) into crossmember (4). Install isolator until isolator can flange contacts surface of crossmember.
Remove tools.

Courtesy of CHRYSLER GROUP, LLC
Install the spacer (1).
Install the engine cradle crossmember (2). Refer to CROSSMEMBER, CRADLE, ENGINE AND SUSPENSION, INSTALLATION .