FixVault
Home › Jeep › 2018 › Grand Cherokee Trackhawk › Repair and Diagnosis › Engine Mechanical › Mechanical › 6.2L Engine (Service Information) › Valve Timing › Cover(S), Engine Timing › Installation

Cover(S), Engine Timing: Installation

  1. Clean the engine timing cover and engine block surface.
    NOTE:

    Always install a NEW gasket when servicing the engine timing cover.

    GC0170372Courtesy of CHRYSLER GROUP, LLC
  2. Using a NEW gasket, install the engine timing cover (1) and tighten the retaining bolts (2) to the proper torque specifications. Refer to TORQUE SPECIFICATIONS .
  3. Install the vibration damper onto the crankshaft. Refer to DAMPER, VIBRATION, INSTALLATION .
  4. Install the water pump. Refer to PUMP, WATER, INSTALLATION .
  5. Install the oil pump pickup tube (2) and the oil pan. Refer to PAN, OIL, INSTALLATION .
  6. Install the generator. Refer to GENERATOR, INSTALLATION .
  7. Install the A/C compressor. Refer to COMPRESSOR, A/C, INSTALLATION .
    GC0170371Courtesy of CHRYSLER GROUP, LLC
  8. Connect the camshaft position sensor (2) wire harness connector (1).
  9. Fill the cooling system with the specified type and amount of engine coolant. Refer to STANDARD PROCEDURE .
  10. Change the engine oil filter and fill the crankcase with the specified type and amount of engine oil. Refer to STANDARD PROCEDURE .
  11. Connect the negative battery cable.
  12. Perform the Refrigerant System Charge procedure. Refer to PLUMBING, STANDARD PROCEDURE .
  13. Start the engine and check for leaks.
About FixVault