FixVault
Home › Jeep › 2018 › Grand Cherokee Trackhawk › Repair and Diagnosis › External Pages › Different car › Section 407 (Exhaust System) › Sensor, Particulate Matter › Installation › Installation

Sensor, Particulate Matter: Installation: Installation

WARNING: This page is about a different car, the 2016 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: PM Sensor & NOx Sensor (1/2)
GC0157423Courtesy of CHRYSLER GROUP, LLC
  1. Install the Particulate Matter (PM) sensor (1) and tighten to 60 N.m (44 ft. lbs.).
    Fig 2: Particulate Matter Sensor, Connectors & Nuts
    GC0158426Courtesy of CHRYSLER GROUP, LLC
  2. Install the PM module (4). Tighten the nuts (2) to 11 N.m (8 ft. lbs.).
  3. Connect the PM sensor wire harness connector (1).
    Fig 3: Module Mounting Bracket & Nuts
    GC0158422Courtesy of CHRYSLER GROUP, LLC
  4. Install the module mounting bracket (2). Tighten the nuts (1) to 11 N.m (8 ft. lbs.).
    Fig 4: Heat Shield & Fasteners
    GC0172164Courtesy of CHRYSLER GROUP, LLC
  5. Install the heat shield (2) and fasteners (1).
    Fig 5: Fuel Filter Shield & Nuts
    GC0157415Courtesy of CHRYSLER GROUP, LLC
  6. Install the fuel filter shield (1). Tighten the nuts (2) 14 N.m (10 ft. lbs.).
  7. Remove the support and lower the vehicle.
  8. Connect the negative battery cables.
About FixVault