FixVault
Home › Jeep › 2019 › Grand Cherokee Altitude, AWD › Repair and Diagnosis › Engine Mechanical › Exhaust System › Sensor, Exhaust Temperature › Removal › Exhaust Gas Temperature Sensor 1/1

Exhaust Gas Temperature Sensor 1/1

  1. Disconnect and isolate the negative battery cable.
    GC0174046Courtesy of CHRYSLER GROUP, LLC
  2. Remove the engine cover (1).
  3. Remove the cowl extension silencer and the side extensions. Refer to SILENCER, COWL EXTENSION, REMOVAL .
    GC0172130Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    The Exhaust Gas Temperature Sensor wire harness is located on top of the transmission accessible from the left side secured to another wire harness by a cable tie.

  4. Disconnect Exhaust Gas Temperature (EGT) sensor 1/1 wire harness connector (1).
    CAUTION:

    The exhaust gas temperature sensor requires care when handling and installing. The exhaust gas temperature sensor is sensitive to knocks and bending. For this reason if the exhaust gas temperature sensor has been dropped, it must not be installed as damage to the sensor may have occurred. Do not remove from packaging until ready to install. Failure to follow these instructions may result in damage to the exhaust gas temperature sensor.

    GC0146433Courtesy of CHRYSLER GROUP, LLC
  5. Remove the EGT sensor 1/1 (7).
About FixVault