Removal And Installation: Installation
WARNING: This page is about a different car, the 2016 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
- Position the module with cover into place and tighten the nuts.
- Connect the ground cable.
- Install the protective cover.
- Reposition and secure the side floor cover into the installed position.
- Secure the silencer panel.
- Install the instrument panel side cover.
- Connect the negative battery cable.
NOTE:
If installing a new Drivetrain Control Module (DTCM), it is necessary to record the last two characters of the code in the area indicated (a) of the Rear Drive Unit (RDU) for performing the self learning procedure.
- Using the diagnostic scan tool, perform the "replacement unit" routine in the misc functions menu of the DTCM.