FixVault
Home › Jeep › 2019 › Renegade Trailhawk › Repair and Diagnosis › External Pages › Different car › Section 1308 (Electronic Control Modules (Service Information)) › Module, Glow Plug › Removal And Installation › Installation

Removal And Installation: Installation

WARNING: This page is about a different car, the 2020 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
GC0146750Courtesy of CHRYSLER GROUP, LLC
  1. Install the glow plug module (2) and securely tighten the fastener (1).
  2. Connect the glow plug module wire harness connector (3).
  3. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
About FixVault