FixVault
Home › Jeep › 2019 › Renegade Trailhawk › Repair and Diagnosis › External Pages › Different car › Section 838 (Electronic Control Modules (Service Information)) › Module, Adaptive Cruise Control (ACCM) › Removal And Installation › Acc Module Bracket › Removal

Acc Module Bracket: Removal

WARNING: This page is about a different car, the 2018 Jeep Renegade. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the front fascia. Refer to FASCIA, FRONT, REMOVAL AND INSTALLATION .
    GC0165311Courtesy of CHRYSLER GROUP, LLC
  3. Using a drill, remove the rivets (1a) holding the bracket (1b) to bumper reinforcement (1c).
  4. Remove the bracket (1b).
About FixVault