FixVault
Home › Jeep › 2019 › Wrangler Unlimited Moab › Repair and Diagnosis › Electrical › Starter › Starting System (Service Information) › Relay, Power Control › Removal And Installation › Installation

Removal And Installation: Installation

  1. Position the Power Control Relay (PCR) for installation.
  2. Install the PCR to ground mount nuts and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  3. Install the nuts on the B+ posts of the PCR and tighten to the proper specification. Refer to TECHNICAL SPECIFICATIONS .
  4. Connect the PCR wire harness connector.
  5. Install the right inner wheel house. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION and SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL AND INSTALLATION .
  6. Remove the support and lower the vehicle.
  7. Connect the negative battery cable(s). Refer to STANDARD PROCEDURE .
About FixVault