FixVault
Home › Jeep › 2020 › Gladiator Altitude, Standard Trans › Repair and Diagnosis › Steering › Power Steering › Steering System › Gear › Removal And Installation › LHD › Removal

Removal And Installation: LHD: Removal

NOTE:

The steering column on some vehicles may not be equipped with an internal locking shaft that allows the ignition key cylinder to be locked with the key. Alternative methods of locking the steering wheel for service should be used.

  1. Place the front wheels in the straight ahead position with the steering wheel centered and secured.
  2. Remove the air cleaner body. Refer to RESONATOR, AIR CLEANER, REMOVAL AND INSTALLATION .
    GC0182357Courtesy of CHRYSLER GROUP, LLC
  3. Remove the two power steering lines (2) from the steering gear.
  4. Disconnect the intermediate shaft from the steering gear. Refer to SHAFT, INTERMEDIATE, REMOVAL AND INSTALLATION .
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Disconnect the pitman arm from the steering gear. Refer to ARM, PITMAN, REMOVAL AND INSTALLATION .
    GC0192913Courtesy of CHRYSLER GROUP, LLC
  7. Remove the four power steering gear bolts (1).
  8. Remove the steering gear.
About FixVault