FixVault
Home › Jeep › 2020 › Gladiator Overland, Automatic Trans › Repair and Diagnosis › Steering › Steering Column › Steering System › Pump › Removal And Installation › RHD › Removal

Removal And Installation: RHD: Removal

  1. Disconnect and isolate the negative battery cable(s). Refer to BATTERY DISCONNECT AND CONNECTION .
  2. Remove the power distribution center. Refer to CENTER, POWER DISTRIBUTION (PDC), REMOVAL AND INSTALLATION .
    GC0192650Courtesy of CHRYSLER GROUP, LLC
  3. Disconnect the two Electric Hydraulic Power Steering (EHPS) pump wire harness connectors (2) and remove the wiring harness routing clips from the EHPS pump.
  4. With the hose clamp released disconnect the supply line (4) from the EHPS pump and secure the hose end higher than the power steering pump reservoir.
  5. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  6. Remove the left front wheel house splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
    GC0192747Courtesy of CHRYSLER GROUP, LLC
  7. Remove the EHPS pump pressure line bolt (2) and remove the EHPS pressure line from the EHPS pump.
  8. Loosen the two power steering pump bracket frame bolts (2).
    GC0192650Courtesy of CHRYSLER GROUP, LLC
  9. With the hose clamp released disconnect the return line (3) from the EHPS pump.
    GC0192781Courtesy of CHRYSLER GROUP, LLC
  10. Remove the EHPS pump (2) from the vehicle.
About FixVault