FixVault
Home › Jeep › 2020 › Grand Cherokee Trackhawk › Repair and Diagnosis › External Pages › Different car › Section 5 (Electronic Control Modules (Service Information)) › Module, Fuel Pump Control › Removal

Module, Fuel Pump Control: Removal

WARNING: This page is about a different car, the 2018 Jeep Grand Cherokee. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the rear seat. Refer to SEAT, FRONT, REMOVAL .
  3. Remove the rear carpet assembly. Refer to CARPET, FLOOR, REMOVAL .
    GC0180925Courtesy of CHRYSLER GROUP, LLC
  4. Disconnect the fuel pump control module wire harness connector (2) from the module.
  5. Remove the fuel pump control module bracket mounting nuts(1).
  6. Remove the fuel pump control modules from the mounting bracket.
About FixVault