FixVault
Home › Jeep › 2020 › Renegade Trailhawk › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) › Module, Fuel Pump Control › Removal And Installation › Installation

Removal And Installation: Installation

  1. Check that the FPCM is not damaged.
  2. Install the FPCM and securely tighten the fasteners.
  3. Connect the wire harness connector to the FPCM connector receptacle.
  4. Install the left rear splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, INSTALLATION .
  5. Connect the negative battery cable. If equipped with an IBS, connect the IBS connector.
  6. Remove the support and lower the vehicle.
About FixVault