FixVault
Home › Jeep › 2020 › Renegade Trailhawk › Repair and Diagnosis › Engine Performance › 1.3L Ignition System › Sensor, Camshaft Position › Removal And Installation › Installation

Removal And Installation: Installation

  1. Install the CMP sensor with a NEW  O-ring and connect the wiring harness connector.
  2. Install the heat shield and securely tighten the bolt.
  3. Install the catalytic converter. Refer to CONVERTER, CATALYTIC, REMOVAL AND INSTALLATION .
  4. Connect the negative battery cable.
  5. Remove the support and lower the vehicle.
About FixVault