FixVault
Home › Jeep › 2020 › Renegade Upland › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (1.3L Fuel System) › Fuel Injection › Sensor, TMAP-Intake Manifold › Removal And Installation › Installation

Removal And Installation: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the intake manifold pressure and temperature sensor and securely tighten the retaining screw.
  2. Connect and lock the wire harness connector to the intake manifold pressure and temperature sensor.
  3. Install the air cleaner body. Refer to BODY, AIR CLEANER, REMOVAL AND INSTALLATION .
  4. Install the engine cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION .
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
About FixVault