FixVault
Home › Jeep › 2021 › Cherokee Altitude, FWD › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (3.2L Engine (Service Information)) › Engine Mounting › Insulator, Engine Mount, Right › Removal

Insulator, Engine Mount, Right: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
  2. Remove the belly pan. Refer to BELLY PAN, REMOVAL .
  3. Remove the left front wheelhouse splash shield. Refer to REMOVAL .
    GC0183773Courtesy of CHRYSLER GROUP, LLC
  4. Remove the fastener (1) and remove the negative battery cable (2) from the transmission (3).
    CAUTION:

    Failure to remove the negative battery cable may overstress to the cable due to bending during service.

  5. Lower the vehicle.
  6. Carefully position a floor jack under the engine for support.
    GC0158452Courtesy of CHRYSLER GROUP, LLC
  7. Remove the engine mount (1) to frame bolts (4).
  8. Loosen the engine mount to strut tower bolt (5).
  9. Remove the center engine mount to engine bracket bolt (3).
  10. Remove the outer engine mount to engine bracket bolts (2).
    GC0159456Courtesy of CHRYSLER GROUP, LLC
  11. If required, remove the engine mount bracket (1) to timing cover bolts (2).
About FixVault