Buckle, Rear Right - Adjustable
To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.
- Working from behind the rear seats, position the rear right seat belt buckle (1) between the rear seat cushions.
- Position the lower anchor of the seat belt buckle to the bracket at the back of the right rear seat upper inner adjuster track.
- Install the bolt (2) that secures the buckle anchor to the bracket at the back of the right rear seat upper inner adjuster track. Tighten the bolt to the proper torque specification. Refer to TORQUE SPECIFICATIONS .
- Adjust the left (60%) rear seat (4) and right (40%) rear seat (3) to their original positions.