Technical Specifications: Notes
NOTE:
Rotor runout specifications are not to be used for diagnosing brake concerns. The values in the table are post turn measurements taken by an on-vehicle brake lathe.
NOTE:
When refacing a rotor, the required rotor runout MUST BE MAINTAINED. Extreme care in the operation of rotor turning (machining) equipment is required.
SPECIFICATIONS
| Brake Rotor | Rotor Thickness | Minimum Rotor Thickness | Rotor Runout * |
|---|---|---|---|
| Front | 28.00 +/- 0.10 mm | 26.00 mm | 0.020 mm |
| 1.10 +/- 0.004 in. | 1.02 in. | 0.0008 in. | |
| Rear | 12.00 +/- 0.10 mm | 10.00 mm | 0.020 mm |
| 0.47 +/- 0.004 in. | 0.393 in. | 0.0008 in. |