Negative Battery Cable: Removal

NOTE:

LHD shown, RHD similar.

NOTE:

Battery terminals must be disconnected only with the ignition key on STOP or removed for at least one minute and never with key on or when the engine is running.

Disconnect the negative battery terminal from battery. Refer to STANDARD PROCEDURE .
NOTE:
Some models have a press disconnect on the negative terminal like that in step 2 if not equipped skip to step 3.

Courtesy of CHRYSLER GROUP, LLC
Press the release (1a) and disconnect the terminal (1b) from the negative battery pole (1c).

Courtesy of CHRYSLER GROUP, LLC
Open the retaining clip (1a) and disengage the ground wire (1b).

Courtesy of CHRYSLER GROUP, LLC
Remove the left front wheel splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
Remove the screw (1a) and disconnect the ground wire (1c) from the gearbox (1d).
NOTE:
The positioning of the terminal (1b) on the gearbox can change depending on the type of gearbox installed.
Remove the nut (2a) and disconnect the ground wire (1c) from the frame.
Recover the ground wire (1c).
Check that the ground wire is not damaged and that the individual wires are securely attached to the connections. If needed, perform continuity checks.