FixVault
Home › Jeep › 2021 › Compass Trailhawk › Repair and Diagnosis › Transmission › Transfer Case › Power Transfer Unit (Service Information) › Actuator, Shift › Removal And Installation › Installation

Removal And Installation: Installation

  1. Position the actuator on the PTU. Install and tighten the bolts to the proper torque specification. Refer to TECHNICAL SPECIFICATIONS .
  2. Connect the actuator wire harness connector.
  3. Install the right front tire and wheel assembly. Refer to REMOVAL AND INSTALLATION .
  4. Remove the support and lower the vehicle.
About FixVault