FixVault
Home › Jeep › 2021 › Grand Cherokee Trackhawk › Repair and Diagnosis › Body & Frame › Seats › Power Seats (Service Information) › Switch, Memory › Removal

Switch, Memory: Removal

NOTE:

Take the proper precautions to protect the face of the door panel from cosmetic damage while performing this procedure.

GC0146079Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
  2. Remove the driver door trim panel and place it on a workbench. Refer to PANEL, DOOR TRIM, REMOVAL .
  3. Disconnect the wiring harness connector (1) from the memory seat switch (2).
    GC0146080Courtesy of CHRYSLER GROUP, LLC
  4. Using Trim Stick (special tool #C-4755, Trim Stick) or equivalent, gently disengage the retaining tabs (1 and 3) securing the memory seat switch (2) to the driver door trim panel (4).
  5. Remove the memory seat switch from the driver door trim panel.
About FixVault