FixVault
Home › Jeep › 2021 › Grand Cherokee Trackhawk › Repair and Diagnosis › Restraints › Restraints Control Systems › Restraints System (Service Information) › Retractor, Seat Belt › Removal › Rear Center

Rear Center

WARNING:

To avoid serious or fatal injury during and following any seat belt or child restraint anchor service, carefully inspect all seat belts, buckles, mounting hardware, retractors, tether straps, and anchors for proper installation, operation, or damage. Replace any belt that is cut, frayed, or torn. Straighten any belt that is twisted. Tighten any loose fasteners. Replace any belt that has a damaged or ineffective buckle or retractor. Replace any belt that has a bent or damaged latch plate or anchor plate. Replace any child restraint anchor or the unit to which the anchor is integral that has been bent or damaged. Never attempt to repair a seat belt or child restraint component. Always replace damaged or ineffective seat belt and child restraint components with the correct, new and unused replacement parts listed in the Mopar® Parts Catalog. Failure to follow these instructions may result in possible serious or fatal injury.

GC0146909Courtesy of CHRYSLER GROUP, LLC
  1. Remove the two screws and two nuts that secure the supports at the front of the second row seat cushion to the rear floor panel. Refer to COVER, SEAT CUSHION, REAR, REMOVAL .
  2. Fold the front of the two sections of the second row seat cushion upward against the second row seat backs (1) and secure them in the upward position.
  3. Remove the screw (2) that secures the center seat belt lower anchor (5) and the left outboard seat belt buckle (3) to the rear floor panel (4).
  4. Disengage the second row left outboard seat belt buckle bracket from the second row center seat belt lower anchor bracket.
  5. Fold the front of the two sections of the second row seat cushion down from the second row seat back (1) and position the supports at the front of the cushion to the rear floor panel.
    GC0145838Courtesy of CHRYSLER GROUP, LLC
  6. Remove the two screws (3) that secure the center seat belt bezel (2) to the top of the left (60 percent) section of the second row seat back (7).
  7. Disengage the bezel from the center seat belt (1) webbing and remove the bezel.
  8. Remove the trim from the front and back of the left section of the second row seat back frame (7). Refer to REMOVAL .
  9. Remove the two screws (5) that secure the center seat belt shield (4) to the top of the left section of the second row seat back frame.
  10. Disengage the shield from the center seat belt webbing and remove the shield.
  11. From behind the back of the seat back, remove the screw (8) that secures the center seat belt retractor to the bracket (6) integral to the seat back frame.
  12. Disengage the T-tab on the retractor frame from the T-slot in the seat back frame bracket.
  13. Disengage the seat belt and lower anchor through the guide integral to the top of the seat back frame.
  14. Remove the second row center seat belt and retractor from the front of the left section of the seat back frame as a unit.
About FixVault