FixVault
Home › Jeep › 2022 › Compass Red › Repair and Diagnosis › Accessories & Equipment › Communication Devices › Electronic Control Modules (Service Information) › Module, Power Liftgate (PLGM) › Removal And Installation › Installation

Removal And Installation: Installation

  1. Install the PLGM and connect the wiring harness.
  2. Install the rear quarter trim. Refer to PANEL, QUARTER TRIM, REMOVAL AND INSTALLATION .
  3. Install the liftgate sill plate. Refer to PLATE, SCUFF, LIFTGATE SILL, REMOVAL AND INSTALLATION .
  4. Install the spare tire and wheel.
  5. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.
About FixVault