Removal And Installation: 2.4L: Installation
- Install the exhaust pipe with intermediate flexible joint and connect it to the muffler.
- Lower the hydraulic lift to bring the powertrain to crossmember.
- Install the rear engine mount isolator to bracket bolt (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS
- Remove the hydraulic lift.
- Engage the two isolators supporting the front exhaust pipe.
- Using a NEW gasket, install the exhaust pipe to the catalytic converter and tighten the NEW nuts (1) to the proper torque specification. Refer to TORQUE SPECIFICATIONS
- Install the front exhaust pipe support bracket bolts (2) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS
- Install the exhaust pipe support bracket bolt (3) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS
- Install the rear support bracket bolts (1) and tighten to the proper torque specification. Refer to TORQUE SPECIFICATIONS
- Tighten the exhaust clamp nut (2) to the proper torque specification. Refer to TORQUE SPECIFICATIONS
- Remove the hydraulic lift.
- Install the right half shaft. Refer to REMOVAL AND INSTALLATION
- Install the right front splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, REMOVAL AND INSTALLATION .
- Install the right front wheel. Refer to REMOVAL AND INSTALLATION .
- Install the engine belly pan. Refer to BELLY PAN, REMOVAL AND INSTALLATION .
- Remove the vehicle from the lift.