Removal And Installation: Installation
WARNING: This page is about a different car, the 2021 Jeep Compass. However, it is still accessible from the selected car via links, so may be relevant.
- Position the generator to the engine compartment for installation.
- Install the upper and lowers generator mounting bolts (1) and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Connect the wiring harness to the generator stud. Install the retaining nut and tighten to the proper torque specifications. Refer to TECHNICAL SPECIFICATIONS .
- Install the exhaust manifold heat shield cover (2).
- Install the oxygen sensor wiring bracket (1).
- Connect the oxygen sensor wiring (1).
- Connect the upstream oxygen sensor wiring harness connector to the sensor (1).
- Install the accessory drive serpentine belt. Refer to BELT, SERPENTINE, REMOVAL AND INSTALLATION .
- Install the right front wheel. Refer to REMOVAL AND INSTALLATION .
- Install the engine beauty cover. Refer to COVER, ENGINE, REMOVAL AND INSTALLATION COVER, ENGINE, REMOVAL AND INSTALLATION COVER, ENGINE, REMOVAL AND INSTALLATION .
- Connect the negative battery cable.