FixVault
Home › Jeep › 2023 › Renegade Red › Repair and Diagnosis › Engine Performance › 1.3L Ignition System › Sensor, Camshaft Position › Removal And Installation › Installation

Removal And Installation: Installation

  1. Install the CMP sensor with a NEW  O-ring and connect the wiring harness connector.
  2. Install the heat shield and securely tighten the bolt.
  3. Install the gas particulate filter. Refer to FILTER, GAS PARTICULATE, REMOVAL AND INSTALLATION .
  4. Connect the negative battery cable.
  5. Remove the support and lower the vehicle.
About FixVault