Removal And Installation

REMOVAL 

1. Disconnect and isolate the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), disconnect the IBS connector first before disconnecting the negative battery cable.
2. Remove the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION .
3. Remove the wireless charging pad mat (1).

   Courtesy of CHRYSLER GROUP, LLC

4. Release the retaining tabs (2) and lift up on the rear of the wireless charging module bracket (1).

   Courtesy of CHRYSLER GROUP, LLC

5. Slide the bracket (1) toward the rear of the vehicle to release it from the front of the floor console.
6. Disconnect the wire harness connector (3) from the wireless charging pad module.
7. Remove the fasteners (1) from the wireless charging module (2) and remove it from the wireless charging module bracket (3).

   Courtesy of CHRYSLER GROUP, LLC

INSTALLATION 

1. Position the wireless charging pad module (2) to the wireless charging bracket (3), then install the fasteners (1) and tighten them securely.

   Courtesy of CHRYSLER GROUP, LLC

2. Position the wireless charging module bracket into the floor console.

   Courtesy of CHRYSLER GROUP, LLC

3. Connect the wire harness connector (3) to the wireless charging pad module.
4. Slide the tab on the front of the wireless charging module bracket (1) into the slot on the front of the floor console.
5. Lower the rear of the wireless charging bracket until the retaining tabs (2) are fully engaged into the floor console.
6. Install the wireless charging pad mat (1).

   Courtesy of CHRYSLER GROUP, LLC

7. Install the shifter bezel. Refer to BEZEL, SHIFTER, REMOVAL AND INSTALLATION .
8. Connect the negative battery cable. If equipped with an Intelligent Battery Sensor (IBS), connect the IBS connector.