Brake System Control Module 2 (BSCM 2) - DTCS C0556-00 To P2535-00

• DTC Troubleshooting
  • C0556-00-Right Front Wheel Speed Sensor Incorrect Component Installed
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C05A3-00-Wheel Speed Sensors Supply Circuit High
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1009-00-Brake Fluid Level Low
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C107B-00-Wheel Speed Comparative Performance
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1239-00-Emissions Rolls Test Active
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C1260-00-Abs/ESC Dynamic Controls Disabled
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2100-00-Battery Voltage Low
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2101-00-Battery Voltage High
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2102-00-System Voltage Low
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2103-00-System Voltage High
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2129-00-Battery Voltage
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2202-00-Original VIN Mismatch/Missing
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2206-00 - Vehicle Configuration Mismatch
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • C2210-00 - Ecu OVERTEMPERATURE
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0602-00-Control Module Programming Error/Not Programmed
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P0604-00-Internal Control Module Random Access Memory (Ram) Error
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P060B-00-Internal Control Module A/D Processing Performance
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P062F-00-Internal Control Module EEPROM Error
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P2534-00-Ignition Switch On/Start Position Circuit Low
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test
  • P2535-00-Ignition Switch On/Start Position Circuit High
    • When Monitored
    • Set Condition
    • Default Action
    • Possible Causes
    • Diagnostic Test