Speed Control Switch

REMOVAL

WARNING:

To avoid serious or fatal injury on vehicles equipped with airbags, disable the Supplemental Restraint System (SRS) before attempting any steering wheel, steering column, airbag, seat belt tensioner, impact sensor or instrument panel component diagnosis or service. Disconnect and isolate the battery negative (ground) cable, then wait two minutes for the system capacitor to discharge before performing further diagnosis or service. This is the only sure way to disable the SRS. Failure to take the proper precautions could result in accidental airbag deployment.

Remove the instrument panel steering wheel bezel. Refer to BEZEL, INSTRUMENT PANEL, STEERING WHEEL, REMOVAL AND INSTALLATION .

Remove the fasteners from the back of the steering wheel bezel.

Courtesy of CHRYSLER GROUP, LLC

1 - Fasteners

2 - Speed Control Switches

3 - Steering Wheel Bezel

Remove the speed control switches from the steering wheel bezel.

INSTALLATION

Follow the removal procedure in reverse for general reassembly of the components on the vehicle. The steps listed below are calling out specific procedures that should be followed during installation.

Tighten the fasteners securely.