CANADIAN Programming/Gate Programming

Canadian RF laws require transmitter signals to time-out after several seconds of transmission which may not be long enough for the HomeLink® transceiver to pick up the RF signal during programming. Similar to this Canadian law, some U.S. gate openers are designed to time-out in the same manner.

If you live in Canada or you are having difficulties programming a gate opener by using the programming procedures, replace "Reprogramming HomeLink® Transceiver Codes" step 3 with the following:

NOTE: When programming a garage door opener or gate opener, it is advised to unplug the device or move the vehicle out of range during the cycling process to prevent possible overheating.

3. Continue to press and hold the HomeLink® transceiver button while you press and release every two seconds cycle your transmitter until the RF signal has successfully been accepted. The indicator light will flash slowly and then rapidly. Proceed with programming step 4 to complete.