Inspection Procedure

1. Connect the hi-scan (pro) to data link connector.
2. Turn the ignition switch to ON and verify the DTC "P1695" is displayed.
3. Erase the DTC "P1695" with the hi-scan (pro) and then monitor again.

Is the same code displayed? 

1. Yes
   
   Go To Next Step.
2. No
   
   Problem is intermittent and engine control module memory was not cleared.

1. Connect the hi-can (pro) to data link connector.
2. Turn the ignition switch to ON and select "TEACHING" mode of immobilizer system on the hi-scan (pro).
3. Input the pin code which consists of 6 digits.
   NOTE: Because the pin code is security code, contact authorized KIA service staff to know the pin code.
4. If the data is correct, the key teaching is completed.

Is the key taught completely? 

1. Yes
   
   Go To Next Step.
2. No
   
   Check for these problems:
   • Storage of invalid data in transponder.
   • Different kind of transponder.
   • Omitted transponder in the key.

1. Connect the hi-scan (pro) to data link connector.
2. Erase the DTC with the hi-scan (pro).
3. Check if DTC "P1695" is displayed again.

Is the same code displayed? 

1. Yes
   
   Go To Next Step.

If all the tests are OK, replace the SMARTRA unit or ECM and recheck.