FixVault
Home › Kia › 2006 › Rio Base, Automatic › Repair and Diagnosis › Engine Performance › System › DTC Troubleshooting Procedures (2 Of 2) › DTC P2232 O2 Sensor Signal Circuit Shorted To Heater Circuit (Sensor 2) › Monitor SCANTOOL Data

Monitor SCANTOOL Data

  1. Connect scantool to Data Link Connector (DLC).
  2. Warm up the engine to normal operating temperature.
  3. Monitor the "B1S2" parameters on the scantool.
    Fig 1: Monitoring B1S2 Parameters
    G04862368Courtesy of KIA MOTORS AMERICA, INC.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or ECM/PCM's connector or was repaired and ECM/PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

About FixVault