Component Inspection

Measure resistance between terminals 1 and 2 of the injector connector (Component side).

SPECIFICATION

INJECTOR (FOR SULEV VEHICLE)

Temperature		OCV Resistance (Ω)	Temperature		OCV Resistance (Ω)
(°C)	(°F)	OCV Resistance (Ω)	(°C)	(°F)	OCV Resistance (Ω)
-20	-4	11.1~12.2	60	140	15.2~16.8
0	32	12.1~13.4	80	176	16.2~17.9
20	68	13.1~14.5	100	212	17.2~19.0
40	104	14.1~15.6	120	248	18.2~20.2

INJECTOR (FOR FED VEHICLE)

Temperature		OCV Resistance (Ω)	Temperature		OCV Resistance (Ω)
(°C)	(°F)	OCV Resistance (Ω)	(°C)	(°F)	OCV Resistance (Ω)
-20	-4	12.2~12.3	60	140	16.6~16.8
0	32	13.3~13.5	80	176	17.7~17.9
20	68	14.4~14.6	100	212	18.8~19.0
40	104	15.5~15.7	120	248	19.9~20.1

Fig 1: Measuring Resistance Between Terminals 1 And 2 Of Injector Connector

Courtesy of KIA MOTORS AMERICA, INC.

Is resistance within the specification?
YES
- Go to TERMINAL AND CONNECTOR INSPECTION procedure.
NO
- Check injector for contamination, deterioration, or damage. Substitute with a known-good injector and check for proper operation. If the problem is corrected, replace injector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.