FixVault
Home › Kia › 2007 › Magentis 2.4 3 › Repair and Diagnosis › External Pages › Different car › Section 57 (Meter) › Combination Meter › Installation

Combination Meter: Installation

WARNING: This page is about a different car, the 2006 Lexus IS 350 and 2006 Lexus IS 250. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL COMBINATION METER GLASS 
    1. Engage the 9 claws and install the combination meter glass.
    Fig 1: Identifying Combination Meter Glass
    G04050047Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL COMBINATION METER ASSEMBLY 
    1. Position the combination meter assembly on the steering column as shown in the illustration.
      NOTE: Do not damage the instrument panel safety pad or combination meter assembly.
    2. Connect the connectors.
      Fig 2: Positioning Combination Meter Assembly On Steering Column
      G04050048Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    3. Engage the 2 positioning pins of the combination meter assembly.
    4. Engage the 2 claws and install the combination meter assembly.
    5. Remove the protective tape.
  3. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY (See  INSTALLATION  ) 
    Fig 3: Identifying Combination Meter
    G04050049Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY 
    1. Install the 2 clips.
      Fig 4: Identifying Clips
      G04050050Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the instrument cluster finish panel subassembly with the 2 screws.
  5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY (See  INSTALLATION  ) 
  6. INSTALL SIDE INSTRUMENT PANEL LH (See  INSTALLATION  ) 
  7. INSTALL FRONT DOOR OPENING TRIM COVER LH (See  INSTALLATION  ) 
  8. INSTALL FRONT DOOR SCUFF PLATE LH (w/o Illumination) (See  INSTALLATION  ) 
  9. INSTALL FRONT DOOR SCUFF PLATE LH (w/ Illumination) (See  INSTALLATION  ) 
  10. INSTALL STEERING COLUMN COVER (for Manual Tilt and Telescopic) (See  INSTALLATION  ) 
  11. INSTALL STEERING COLUMN COVER (for Power Tilt and Power Telescopic) (See  INSTALLATION  ) 
  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  13. PERFORM INITIALIZATION 
    Fig 5: Identifying Instrument Cluster Finish Panel Subassembly With Screws
    G04050051Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    NOTE: Some systems need initialization after reconnecting the cable to the negative battery terminal (See INITIALIZATION ).
About FixVault