FixVault
Home › Kia › 2007 › Rio Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 8 (Abs (Anti-Lock Brake System)) › Anti-Lock Braking System Control Module › Removal

Anti-Lock Braking System Control Module: Removal

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner. (Refer to ENGINE AND TRANSAXLE ASSEMBLY .)
  2. Disconnect the brake tube from the HECU by unlocking the nuts counterclockwise with a spanner.
    Fig 1: Identifying Brake Tube locking Nuts
    G04883903Courtesy of KIA MOTORS AMERICA, INC.
  3. Disconnect the connector(A) from the HECU.
    Fig 2: Identifying Connector(A)
    G04883904Courtesy of KIA MOTORS AMERICA, INC.
    Fig 3: Identifying HECU Brake Mounting Bolts And Nuts
    G04883905Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the two HECU brake mounting bolts(B), and then disassemble the HECU with the bracket.
    CAUTION:
    1. Never attempt to disassemble the HECU.
    2. The HECU must be protected during storage and transport, and must not be subjected to excessive shock.
  5. Remove the two HECU mounting nuts (C) and washer, and then remove the bracket.
About FixVault