FixVault
Home › Kia › 2007 › Sedona EX › Repair and Diagnosis (Single Page) › Engine Mechanical › Lubrication System › Engine Mechanical › Cooling System › Installation › Water Temperature Control Assembly

Water Temperature Control Assembly

NOTE: Make clean the contact face before assembly.
  1. Install water temperature control assembly (B) and new gasket (A).

    Tightening torque 

    18.62-23.52 N.m (1.9-2.4 kgf.m, 13.74-17.36 lb-ft)

    NOTE: Use new O-rings (C) when reassembling.
    Fig 1: Identifying Water Temperature Control Assembly, Gasket And O-Ring
    G04883129Courtesy of KIA MOTORS AMERICA, INC.
  2. Connect water hoses to the water temperature control assembly.
  3. Install wiring protector.
  4. Connect ECT connector.
  5. Connect radiator upper and lower hose (A).
    Fig 2: Locating Radiator Upper And Lower Hoses)
    G04882936Courtesy of KIA MOTORS AMERICA, INC.
  6. Install air cleaner assembly.
  7. Fill with engine coolant.
  8. Start engine and check for leaks.
  9. Recheck engine coolant level.
About FixVault