Ignition Lock Switch

Disconnect 2P-connector from a ignition lock switch.
Disconnect the ignition lock switch. (if you can install a tester with the switch fixed, this step can be omissible)

Check for continuity between terminals. See CLUTCH PEDAL POSITION .

CLUTCH PEDAL POSITION

Clutch pedal position	Ignition lock switch	Continuity
Released	Released	NO
Pressed	Pressed	YES

If there is difference between what tested and the table above, replace the ignition lock switch with a new one.

If not, install the ignition lock switch and adjust the clutch pedal.

TORQUE:

7.8-9.8 N.m (80-100 Kgf.cm, 5.8-7.2 lb-ft)