FixVault
Home › Kia › 2008 › Magentis 2.7 4 › Repair and Diagnosis (Single Page) › Engine Performance › System › DTC Troubleshooting Procedures (2 Of 2) - 2.7L › DTC P061B Internal Control Module Torque Calculation Performance › Monitor DTC Status

Monitor DTC Status

  1. Connect scan tool to Data Link Connector (DLC).
  2. IG "ON".
  3. Select "Diagnostic Trouble Codes (DTCs)" mode, and then Press F4(DTAL) to check DTC's information from the DTCs menu
  4. Read "DTC Status" parameter.
    Fig 1: Scan Tool Display DTC Status
    G04804533Courtesy of KIA MOTORS AMERICA, INC.
  5. Is parameter displayed "Present fault"?

    YES  : --> Diagnose and repair as necessary.

    NO  : --> Fault is intermittent, go to "VERIFICATION OF VEHICLE REPAIR " procedure.

About FixVault