Verification Of Vehicle Repair

After a repair, it is essential to verify that the fault has been corrected.

1. Connect scan tool and select "Diagnostic Trouble Codes (DTCs)" mode.
2. Using a scan tool, Clear DTC.
3. Operate the vehicle within DTC Detecting Condition. See DTC DETECTING CONDITION . Start and drive vehicle in gear and maintain vehicle speed is approx. 12 km/h or more (7.5 mph or more).
4. Are any DTCs present ?

   YES  : --> Go to the applicable troubleshooting procedure.

   NO  : --> System performing to specification at this time.