Rear Disc Brake: Installation

WARNING: This page is about a different car, the 2007 Kia Sedona and 2006 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

Install the pad retainer (A) to the caliper bracket.
Install the brake pads (B) and pad shims (A) and Install the pad with the wear indicator (C) on the inside.

Fig 1: Identifying Pad Shim And Pads
Courtesy of KIA MOTORS AMERICA, INC.

CAUTION: If you reuse the pads, check for foreign material between the pad shim (A) and the back of the pads (B) and reinstall the brake pads in their original position to prevent a momentary loss of braking efficiency.
Press in the piston with the special tool (09581-11000).

Fig 2: Identifying Special Tool (09581-11000)
Courtesy of KIA MOTORS AMERICA, INC.
Grease the piston boot to prevent from twisting.
Install the guide rod.
Install the cylinder assembly (A) to the disc plate.
CAUTION: Be careful not to damage the piston boot.

Fig 3: Identifying Guide Rod Bolt And Caliper Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Install the guide rod bolt (B).
Tightening torque N.m (kgf.m, lb-ft): 22-32 (2.2-3.2, 15.9-23.1)