Component Inspection

Check parking lamp
1. Ignition "ON" & engine "OFF".
2. Disconnect parking lamp light bulb.
3. Measure the resistance between both terminals of parking lamp light bulb.
  Specification: approx. 0.04 Ω
  
  (If light bulb fails, ∞ Ω is measured.)
  
  Fig 1: Measuring Resistance Between Both Terminals Of Stop Lamp Light Bulb
  Courtesy of KIA MOTORS AMERICA, INC.
4. Is the measured resistance within the specification?
  YES
  
  Go to step 2.
  
  NO
  
  Replacing the light bulb with `light bulb for test', if normal operating condition is confirmed, Replace `light bulb for test' with `new light bulb' and go to "VERIFICATION OF VEHICLE REPAIR ".
Check FAM
1. Connect scan tool to Data Link Connector (DLC).
2. Ignition "ON" & engine "OFF".
3. Check if DTC is erased after replacing FAM with "FAM for test".
4. Is the DTC erased?
  YES
  
  Replace "FAM for test" with "new FAM" and go to "VERIFICATION OF VEHICLE REPAIR ".
  
  NO
  
  Check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace if necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.