FixVault
Home › Kia › 2009 › Borrego Limited, 4WD › Repair and Diagnosis › Restraints › Restraints Control Systems › SRS Control Module (SRSCM) › Passenger Occupant Detecting Sensor (PODS) › Repair Procedure › Installation

Repair Procedure: Installation

  1. Install the PODS equipped seat front assembly. (Refer to FRONT SEAT )
  2. Reconnect the battery negative cable.
  3. After installing the PODS, confirm proper system operation :
    1. Turn the ignition switch ON; the SRS indicator should be turned on for about six seconds and then go off.

    Telltale lamp will turn on for 4 seconds and be turned off for 4 seconds. After the 8 seconds, it shall remain off if the PODS does not require suppression and the passenger airbag is enabled.

    NOTE: Be sure to perform PODS reset with scantool after replacing PODS equipped seat cushion.
About FixVault